| 电感测量仪具有简单实用的分选功能 |
| 添加时间：2019/5/7 15:20:44 浏览次数： |
| 电感测量仪具有简单实用的分选功能，此功能的参数设置简便易行，结果显示直观，可以满足人们使用单位的进货检验和电感生产线的快速分选测量要求。该电感测试仪采用桥式电路结构，标准电感器和被试电感器作为桥式电路的两臂。当进行电感器电感值测量时，测试电压同时施加在标准电感器和被试电感器上，处理器通过传感器同采集流过两者的电流信号并进行处理后得被试电感器的电感值。 The inductance measuring instrument has a simple and practical sorting function. The parameter setting of this function is simple and easy, and the result shows intuitively. It can satisfy the requirements of wufangbu.07858.netxinban.07858.netlalijii.07858.netshiyanji.07858.netliuhuaji.07858.net liuhuajii.07858.netrapid sorting and measuring of the unit used and the inductance production line. The inductance tester adopts bridge circuit structure. The standard inductor and the tested inductor are the two arms of the bridge circuit. When measuring inductance value of inductor, the test voltage is applied to both standard inductor and tested inductor. The inductance value of tested inductor is obtained by the processor through the sensor and the current signal flowing through both inductors. 由于采用标准电感器、被试电感器同步采样技术，可不受电源电压波动的影响;加之测量过程是全自动进行的，避免了手动操作引起的误差，因此具有稳定性好、重复性好，准确可靠的特点。 Because the synchronous sampling technology of standard inductor and tested inductor can not be affected by the fluctuation of power supply voltage, and the measurement process is automatic, which avoids the error caused by manual operation, so it has the characteristics of good stability, good repeatability, accuracy and reliability. |
| 上一页 6-35kV氧化锌避雷器下端一般不带计数器 |
| 下一页 避雷器放电计数器测试仪使用方法与注意事项 |
Copyright © 技术支持：遨游网络