| 电容电感检测仪结构说明 |
| 添加时间：2018/5/18 14:41:22 浏览次数： |
| 电容电感检测仪结构说明 Structure description of capacitance and inductance detector 1是电流输入——电流信号输入端，测试电流信号电缆插在“电流输入”输入插头上，另一端连于钳形表上. The 1 is the current input, the current signal input terminal. The test current signal cable is inserted in the "current input" input plug, and the other end is connected to the clamp meter. 2是25V/20A交流输出端，测试电压电缆一端接到“电压输出”端子上，另一端的电缆夹分别夹在被测电容器组两极的连接母线上；3是2V/20A交流输出端，测试电抗器小于5mH或电阻小于1.25Ω时，接入2V电压输出端子上，电容器测试直接使用20V电压； The 2 is 25V/20A AC output terminal, one end of the test voltage cable is connected to the "voltage output" terminal, and the cable clip on the other end is sandwiched on the connecting bus of the two poles of the measured capacitor group. The 3 is the AC output terminal, when the reactor is less than 5mH or the resistance is less than 1.25 Omega, the capacitor test is directly connected to the 2V voltage output terminal and the capacitor test is directly tested. Use 20V voltage; 打印机——打印测试结果，使用宽度 58mm热敏打印纸。换纸时要打开打印机的纸仓盖板，放入纸卷并留少许部分在外面，然后关闭盖板； Printer -- print test results and use width 58mm thermal print paper. When changing the paper, open the paper cover plate of the printer, put it in the paper roll and leave a few parts outside, then close the cover plate. 电源插座——接220V市电，该插座内含保险丝，本仪器应安装5A保险丝管； Power socket - 220V power, the socket contains fuse, this instrument should install 5A fuse tube. 键盘——“↓”键 向下移动光标，或修改数字时减小数字； Keyboard - "button" moves the cursor down or changes the number to reduce the number. “↑”键 向上移动光标，或修改数字时增加数字； The "key" moves up the cursor or adds the number when modifying the number. “→”键 向右移动光标； The "-" key moves the cursor to the right. “打印”键 按该键打印测试结果； The "print" key prints the test results according to the key. “确定”键 按此键确定操作； The "determine" key determines the operation by this key. “复位”键 按此键返回上一级菜单； The "reset" key returns the upper level menu according to this key. 接地端子——工作时，必须将此端可靠接地； Earthing terminal must be reliably grounded when working. |
| 上一页 电感检测仪的功能 |
| 下一页 氧化锌避雷器带电测试仪 |
Copyright © 技术支持：遨游网络