河北电气厂-氧化锌避雷器带电测试仪,电感检测仪

1、电压电缆一端接到电压输出端子上;

1. One end of the voltage cable is connected to the voltage output terminal;

2、测试电流信号电缆插在电流输入插头上，

2 、 test current signal cable inserted in current input plug,

3、接好电容电桥电源线。

3. Connect the capacitor bridge power cord.

4、将测试电压电缆分别夹在被试电容器组两极的连接母线上，钳形表卡在所需测量的单台电容器的套管处。

4, the test voltage of the cable are respectively clamped in the connecting bus capacitor to be tested on the polar group, tube clamp meter card in a single capacitor required for the measurement of.

注意：一定要将电压输出红端线从钳形表正面穿过后再接到需测量的单台电容器(电抗器)的套管处，接反时测量不准确。

Note: must be a single capacitor voltage output from the red line and then received through the front clamp meter to measure the casing (reactor), reversed when the measurement is not accurate.