电容电感测试仪接线方法
Wiring method of capacitance and inductance tester
Y形联接A相接线： 仪器面板接线： ① 黑色测量线插在（输出）； ② 红色测量线插在（电容）； ③ 钳形电流传感器插在（测量）； 按接线图（1）三相Y形A相测量接线方法，测量线由仪器测量输出端对应插好，将红色夹子夹在母线排A相上、黑色夹子夹在母线B相上，然后将电流测量线插在仪器接口上拧紧、钳形传感器应套在高压电容器组A相引线上，方可测量，完成后转下一相接线，其他相测试的接线方法与上图一致，只需要改变测试项的顺序即可
Y-connection A-phase wiring: instrument panel wiring: ① Insert Black measuring wire into (output); ② insert red measuring wire into (capacitance); ③ insert clamp current sensor into (measurement); according to wiring diagram (1) three-phase y-phase A-phase measurement wiring method, the measuring wire is inserted by the instrument measurement output end correspondingly, clamp red clamp on phase a of bus bar and Black clamp on phase B of bus bar Then, insert the current measuring wire into the instrument interface and tighten it. The clamp type sensor should be sleeved on the A-phase lead of the high voltage capacitor bank before measurement. After completion, turn to the next phase wiring. The wiring method of other phase tests is the same as the above figure, just change the sequence of test items