电感测量仪接线方法
Connection method of inductance measuring instrument
1、电压电缆一端接到电压输出端子上;
1. One end of the voltage cable is connected to the voltage output terminal.
2、测试电流信号电缆插在电流输入插头上，
2, test the current signal cable to plug in the current input plug.
3、接好电容电桥电源线。
3. Connect the power line of the capacitive bridge.
4、将测试电压电缆分别夹在被试电容器组两极的连接母线上，钳形表卡在所需测量的单台电容器的套管处。
4, the test voltage and cable are clamped on the connecting bus poles of the two poles of the tested capacitor bank. The clamp meter is stuck to the sleeve of the single capacitor that needs to be measured.
注意：一定要将电压输出红端线从钳形表正面穿过后再接到需测量的单台电容器(电抗器)的套管处，接反时测量不准确
Note: it is necessary to pass the voltage out of the red end line from the front of the pincer form and then to the casing of the single capacitor (reactor) that needs to be measured, and the measurement is inaccurate.